Aluminum 10 mm shadow gap profile painted 2.5 m

240 ₴

BrandUKRFLOOR

MaterialАлюміній

StateNew

Unitm

Delivery / pickupNova Poshta

DimensionsДовжина - 2500-3000мм

Profile for drywall

2 months

Україна

Київська область

Київ Get directions →

03110 - вул.Соломянська 1

156 views

Published 2 months ago by UKRFLOOR™

240 ₴

In Profile for drywall category

вул.Соломянська 1, 03110 Київ, Київська область, Україна

Get directions →

156 item views

Art. UKF-1020RAL
Country of manufacture: Ukraine
Type of profile: Ceiling
Material: Aluminum
Coating: Painted
Height: 46.6 (mm)
Width: 39.1 (mm)
Length: 2500 (mm)
Condition: New

Aluminum 10 mm shadow gap profile painted is used to create a shadow gap at the junction of the ceiling and walls around the perimeter of the room. Made of aluminum with or without coating, depending on requirements.

Advantages:

Quick installation
Even shadow gap along the entire length of the room perimeter
Allows you to do without cornices and ceiling moldings.
Fully meets technical requirements

Installation of the shadow gap profile:

The walls are leveled in advance, after which an ideally straight horizontal line is applied to the walls, which is the mark of the ceiling level (for this it is better to use a laser level). The resulting line must necessarily close, i.e., end at the starting point; any shift is not allowed.

Next, a painted aluminum shadow gap profile (SGP) is fastened around the entire perimeter of the room (it serves as a guide profile and at the same time replaces the standard guide profile for drywall).

In places where the SGP meets the wall, a sealing tape should be glued (for example, “Dichtungsband”).

The standard length of the SGP is 2.5 m; when fastening such long elements, the connection to the wall must occur in at least 4 places.

The anchors used for fastening should have a "mushroom" head similar to a washer. Such fastening creates a durable and reliable connection because it enhances the contact of the profiles with the wall.

It is better to install the anchors in the classic way: screwing in the plug and then installing the screw in it.

Gaps between shadow gap profiles are not permissible.

Next, the ceiling is assembled according to the standard drywall ceiling technology.

Overall, the entire installation of such a system does not differ from the standard technology for installing drywall ceilings, only in this case the standard 27x27 guide profile around the perimeter of the walls is replaced by the shadow gap profile, while the same technical requirements must be observed. That's all the differences.

Published on 2026/07/23. Modified on 2026/09/20.

Description

Art. UKF-1020RAL
Country of manufacture: Ukraine
Type of profile: Ceiling
Material: Aluminum
Coating: Painted
Height: 46.6 (mm)
Width: 39.1 (mm)
Length: 2500 (mm)
Condition: New